Aeroflow 450 series hose, ideal for performance and racing car builders alike. A high quality, lightweight hose that is easier to assemble than traditional braided steel hose.
An inner core of chorinated polyolyethylene (CPE) or nitrile rubber, is reinforced with an embedded with stainless steel, with a braided nylon outer shield for abrasion resistance.
Available in a wide range of sizes and perfect for use outside the cockpit if being used for fuel and compatible with fuel systems, E85, E10, methanol, oils, lubricants, coolants and in vacuum applications.
Suitable for use Aeroflow 100, 150, 500 & 550 series hose fittings
Please Note: Due to the use of unknown additives in some fuels, we are unable to guarantee our rubber hose's compatibility with all fuels unless otherwise stated. We recommend the use of Aeroflow's PTFE series hose for all other types of fuels.
Please ensure all hose is thoroughly cleaned out before use. For all inlet/suction side of any pump, or when very tight bends must be made, please use the Aeroflow inner coil support spring.
NOT RECOMMENDED FOR: Brake systems, Power steering, Extreme heat areas and use inside passenger compartments (due to permeation). For these applications please use the Aeroflow 200 Series hose & compatible fittings.
- Reinforced with embedded stainless steel
- Chorinated Polyolyethylene (CPE) rubber
- Use with 100, 150, 500 & 550 fittings
- Braided Nylon outer for abrasion resistance
- For fuel, E85, E10, Methanol & lubricants
- Also coolant systems & vacuum applications
- Temperature range of -40°C to 150°C
.jpg)
.jpg)
.jpg)
